Insight note · 13 November 2026

EU tinplate import budgets: modelling the duty change

Anvilmore Research Team

Illustration: A compact two-pallet tinplate staging area: one strapped bundle of bright rectangular steel sheets beside one pallet carrying a small orderly group of upright empty silver steel cans.

For EU buyers of Chinese-origin tinplated steel, the change from a 25% to a 50% out-of-quota steel duty does not fully describe the change in the combined steel and anti-dumping duty component. A comparison of the published provisions produces increases of 38.1–50 percentage points across the four anti-dumping rate bands, on an unchanged value base and under the conditions below.

The difference comes from how the two duties interact. Under Article 4 of the tinplate anti-dumping regulation, the former steel safeguard displaced all or part of the anti-dumping duty. Where both applied, the combined component was effectively the higher of 25% or the applicable anti-dumping rate.

The replacement steel framework applies from 1 July 2026. Article 2(3) sets a 50% out-of-quota duty; recital 16 describes it as additional to other duties. The old suspension clause expressly names the former safeguard. Our model therefore adds 50 points to each anti-dumping rate when comparing the two published structures. This is an interpretation of those provisions for a controlled comparison, not a verified customs assessment of an actual shipment.

Holding the value base constant

The table assumes tinplate within both measures, entitlement to the stated anti-dumping rate, imports outside quota in both regimes and the same pre-duty Union-frontier value. It models full addition of the new duty, without other duties, taxes, reliefs or price changes. The input rates include the July 2025 correction to the original tinplate regulation.

Anti-dumping rate Former combined component New modelled component Increase
13.1% 25.0% 63.1% 38.1 points
46.7% 46.7% 96.7% 50.0 points
24.5% 25.0% 74.5% 49.5 points
62.3% 62.3% 112.3% 50.0 points

These percentages apply to the assumed value base. They are neither increases in the supplier's price nor complete landed-cost estimates.

Two different comparisons

The historical increase and the cost of losing quota treatment are different quantities. In the former structure, the additional duty component outside quota ranged from zero to 11.9 points across these bands: an anti-dumping rate already above 25% left no further component for the old safeguard to add.

In the new stacking scenario, moving from within quota to outside it adds 50 points in every band. That does not make the historical increase uniformly 50 points, because the former combined starting amounts differed.

For procurement and finance, the practical gain is a more specific bridge between an earlier allowance and a current estimate. Adding 25 points to the former combined component falls short of this model by 13.1–25 points. A dated transaction estimate must still establish the duties actually applicable; this comparison explains why the headline rate change alone cannot reconcile the duty reserve.

Sources

EU steel framework 2026/1384, Article 2(3), recital 16 and Article 14; tinplate regulation 2025/1042, consolidated 18 April 2026, Articles 1 and 4; authentic rate corrigendum, 22 July 2025.